At a simplistic level : Beast Lab is a toy playset where children go through a process of adding ingredients, then turning a mock heat dial and placing their finger on a finger scanner. Ultimately they will then pull the emergency lever to reveal a beast inside.

There are 4 Beast Species:

• Sharks
• Reptiles
• Cats
• Dinosaurs

6 Beasts can only be found at specific retailers.

For instance, Dinosaurs are only found in Walmart; Cats are only found on Amazon & Reptiles are exclusive to Target.

The 2 Shark beasts can be found in any retailer

• 1 X 8” Beast (electronic action figure)
• 1 x instruction manual
• 5 x experiment ingredients
• 8+ bio mist cycles
• 1 x playset (Beacon)
• 1 x mini beaker
• 1 x weapon

• 1 of 2 possible beast species to create
• Science flask w/ drain reveal
• Electronic power control base unit
• Thumb print scanner
• Temperature control dial
• Emergency release lever
• Includes enough mist for 8+ playthroughs.
• 80 + sound effects & lights
• Electronic & interactive 8” action figure with weapon for hours of battle play!
• Weapon punch action

A copy of all the Beast Lab instruction manuals can be found here

Mist refills and extra ingredients can be purchased with the refill pack. This pack can be found at any retailer selling Beast Lab.

Yes, you can also use your own ingredients in the Beast creation process.

You can play with the Beast Creator in a “free play mode”. Place the power mode switch into the down position to power on unit then play without bio mist.

While playing in the creation mode (power mode switch in up position), the unit will require you to follow steps in a specific order. The unit will play an error sound and not allow you to progress until heat dial / chamber are in the correct positions.

Check the following:
– If an error sound is playing while the heat dial is flashing – the heat dial is in the incorrect position; adjust the heat dial until the error sound stops playing. The heat dial is now in the correct position.
– If an error sound is playing while the chamber is flashing – the chamber is not placed properly onto the base. Lift the chamber and place it back on the base, then flip the locking latches to secure chamber to base.

Check to make sure that the emergency lever is in the up position. If the emergency lever is in the down position when the chamber is placed onto the base, it will engage in the draining function.

The mist effect may trigger particle-based smoke detectors. Do not use while in close proximity to any smoke detectors.

Use in a well-ventilated room, and do not use anything other than the approved refill kits to replenish the vegetable glycerin (which is the mist effect).

When the mist is released to reveal the Beast Lab Action Figure, it will have a significant fog-like effect and may also have a mild odor. Please be assured that it has been extensively tested and has been assessed by multiple independent, certified child-safety specialists ensuring there are no potential health and safety risks.

To generate the mist effect we have used Vegetable Glycerin which is safe for human consumption. It does not contain any animal by-products.

In case of accidental eye contact with smoke, flush eyes with water for 10 minutes. Then seek medical attention if irritation persists.

These batteries are required:
Lab Playset: 6 x AA Batteries (not included)
Beast: 3 x LR44 Batteries (included in the beast)

Have you removed the last cable tie that is attached to the grey tube on the side of the cylinder? Failure to remove this will prevent the liquid from draining.

Please hold the chamber upside down and then press and hold the clear refill button which is on the black rim of the cylinder.